Gas Line Assembly 5/16" - Ball Lock Disconnect w/ Check Valve

Gas Line Assembly 5/16" - Ball Lock Disconnect with Check Valve

This is a fully assembled gas line ready to connect your CO2 regulator to a ball lock keg. It comes with 3 feet of 5/16" ID red gas hose, a gas (In) ball lock disconnect with a built-in check valve, a 1/4" MFL to 5/16" barbed swivel nut, and an Oetiker clamp. A worm clamp is also included so you can attach the line to your regulator or CO2 air distributor.

The check valve built into the disconnect keeps beer and liquid from backing up into your gas line if pressure drops. That's a common problem on gas lines without one, and it can ruin a disconnect or foul your regulator over time. This one stops the backflow before it starts.

The swivel nut comes clamped to the hose, so there's no crimping or fittings to assemble on your end. Connect the swivel nut to your regulator or distributor, snap the ball lock onto your keg's gas post, and you're pressurizing.

Specifications

• 3 ft gas hose - 5/16" I.D. x 9/16" O.D.
• Gas (In) ball lock disconnect with built-in check valve
• 1/4" MFL to 5/16" barbed swivel nut, clamped to hose
• Oetiker clamp installed on swivel nut end
• Worm clamp included for regulator or distributor connection
• Fully assembled and ready to use

Highlights

• 3 ft of 5/16" ID gas hose, fully assembled and ready to use.
• Ball lock gas (In) disconnect with built-in check valve stops liquid backflow.
• 1/4" MFL swivel nut comes clamped to the hose—no assembly on your end.
• Includes a worm clamp for connecting to your regulator or CO2 distributor.
• Fits standard ball lock (Cornelius) keg gas posts.

Specifications