Push-In Fitting - 9.5 mm (3/8 in.) Tee - NSF

Push-In Fitting - 9.5 mm (3/8 in.) Tee - NSF Approved

This Push Fitting NSF Approved Tee is 9.5mm and designed to be used with 3/8" / 9.5mm OD hose. 

Keep the following in mind when using fittings:

• You need to cut your hose straight (not at an angle) and firmly push the hose into the fitting until it locks in place.
• If you need to remove the hose, but pull back on the collet. 
• Can be used with liquid or gas. Made from acetal plastic and the o-rings are made from EPDM, which is chemical resistant.
• Do not use with chlorinated cleaning solutions, including bleach. This will degrade the plastic. 
• No clamps are used. The hose is clamped internally by the collet and o-rings.
• Temperature rated to boiling (212) and pressure rated to 150PSI,