Push-In Fitting - 8 mm (5/16 in.) Tee - NSF

Push-In Fitting - 8 mm (5/16 in.) Tee - NSF Approved

This Push Fitting NSF Approved Tee is 8mm and designed to be used with 5/16" / 8mm OD hose. 

Keep the following in mind when using fittings:

• You need to cut your hose straight (not at an angle) and firmly push the hose into the fitting until it locks in place.
• If you need to remove the hose, but pull back on the collet. 
• Can be used with liquid or gas. Made from acetal plastic and the o-rings are made from EPDM, which is chemical resistant.
• Do not use with chlorinated cleaning solutions, including bleach. This will degrade the plastic. 
• No clamps are used. The hose is clamped internally by the collet and o-rings.
• Temperature rated to boiling (212) and pressure rated to 150PSI,

Push-In Fitting - 8 mm (5/16 in.) Tee Fitting