MixRite SE3060ECR2 60x30 Stainless Steel Equipment Stand

The MixRite SE3060ECR2 is a 60x30 stainless equipment stand built to carry heavy countertop cooking equipment in a commercial kitchen. It's the largest stand in Atosa's 30 inch series and the only one with six legs, since the extra length needs the added support.

Highlights

• NSF certified for use in commercial kitchens.
• Six legs and an H-shaped rib under the top spread the load across the full 60 x 30 surface.
• Holds up to 900 lbs on the top shelf and 700 lbs on the undershelf.
• Ships knocked down with assembly tools included, so it packs flat and bolts together on site.
• An optional caster set (part WA400001) lets you roll it around the kitchen instead of bolting it in place.

MixRite SE3060ECR2 Equipment Stand Features

• Full stainless construction: the top, undershelf, hat channel, legs, and sockets are all 18-gauge stainless steel, not just the surface you see.
• Hemmed edge: a raised lip runs along the sides and back of the top so pans, utensils, and small parts don't slide off during a rush.
• H-shape reinforcing rib: a rib welded under the top spreads weight evenly across the full span instead of letting it sag in the middle.
• Adjustable undershelf: the lower shelf slides up or down the legs, giving you a place to keep pots, pans, or backup supplies within reach.
• Bullet feet: adjustable feet let you level the stand on a kitchen floor that isn't perfectly flat.

60x30 Stainless Equipment Stand Specifications

• Exterior dimensions: 60-1/4 in W x 30 in D x 25-3/4 in H.
• Legs: six, 18-gauge stainless steel.
• Net weight: 70.1 lb, 79.8 lb as shipped.
• Weight capacity: 900 lb on the top shelf and 700 lb on the undershelf.
• NSF certified.

Built for Restaurant and Bar Kitchens

This stand is meant to sit under a griddle, charbroiler, fryer, or other countertop unit that's too heavy or too hot to set directly on a prep table. Raising the equipment to counter height also keeps cooks from bending over it all shift. The stainless top and legs resist corrosion from grease and steam, and they wipe down the same way the rest of your line does.

Equipment Stand Shipping and Assembly

It ships knocked down (KD) to keep freight costs down, and the hardware and tools you need for assembly are in the box. Plan on putting it together with a couple of wrenches rather than pulling it out fully assembled. If you'd rather roll it than bolt it down, Atosa sells a caster set separately (part WA400001, four 5 inch casters with a 1-1/2 inch expanding stem) that fits the stand's leg sockets.

Dimensions: 60-1/4"x30"x25-3/4". Material: Stainless Steel.

Specifications