Continuous Soda Carbonator Keg Lid

Continuous Soda Carbonator Keg Lid

Enjoy Soda Water On Tap—Anytime, At Home

There’s nothing quite as refreshing as crisp, sparkling soda water straight from the tap—and now, you can enjoy it without the hassle of constantly refilling small bottles or replacing pricey CO2 cylinders. While SodaStream machines are convenient, they often fall short for frequent users. That’s where the Continuous Soda Carbonator Keg Reactor Solution steps in.

This innovative system features a specially designed keg lid that fits any standard ball lock keg, transforming it into a continuous soda water carbonator. It’s an efficient, cost-effective upgrade that delivers endless fizz at your fingertips.

For the Carbonator Keg Lid to work well, the mains water pressure should be 10-15 psi higher than your regulator set pressure.

That's it. This simple unit will give you continuous soda water connected to your mains water.

Setup Instructions:

1. Chill the Keg:
   Place your keg in a refrigerator or kegerator, keeping the temperature below 40°F (4°C) for optimal carbonation.

2. Connect the Beverage Line:
   Attach your soda water draft line to the liquid out post of the keg.

3. Connect the Gas Line:
   Hook up your CO2 gas line to the gas-in post. Set your regulator pressure between 30–50 psi, depending on your desired carbonation level. Tip: Use a check valve on the gas line to prevent backflow.

4. Purge the Headspace:
   Before use, release any air from the keg’s headspace to ensure proper carbonation.

5. Connect the Water Supply:
   Attach your mains water line to the water inlet post on the keg lid.