Push-In Fitting - 8 mm (5/16 in.) x 9.5mm (3/8") Reducer - NSF

Push-In Fitting Reducer - 8 mm (5/16 in.) x 9.5mm (3/8 in.)

This NSF approved push fitting is designed allow you to reduce or expand from 5/16" OD tubing to 3/8" OD tubing. 

Keep the following in mind when using push fittings:

• You need to cut your hose straight (not at an angle) and firmly push the hose into the fitting until it locks in place.
• If you need to remove the hose, but pull back on the collet. 
• Can be used with liquid or gas. Made from acetal plastic and the orings are made from EPDM, which is chemical resistant.
• Do not use with chlorinated cleaning solutions including bleach. This will degrade the plastic. 
• No clamps are used. The hose is clamped internally by the collet and orings.
• Temperature rated to boiling (212) and pressure rated to 150PSI.

Push-In Fitting Reducer - 8 mm (5/16 in.) x 9.5 mm (3/8 in.)