Duotight Gas In Ball Lock Disconnect

Duotight Gas In Ball Lock Disconnect

This is a gas-side ball lock disconnect with a Duotight push-in fitting built right into the body. That means no barb, no clamp, and no extra fittings to buy. You push your 8mm tubing straight into the back of the QD and you're done. It connects to the gas post on any standard ball lock keg, so if you're running Corny kegs for beer or seltzer, this is the fitting that carries your CO2 into the keg.

The push-in connection holds tight under pressure and pulls apart by hand when you need to break it down. And because there's no clamp involved, cleaning is fast—it disassembles tool-free so you can flush it out and get it back in service.

Built to Handle Sanitizers and Caustics

The springs and ball bearings inside are stainless steel, and the body material stands up to the sanitizers and caustics you'll run through a keg system. So you don't have to worry about it degrading after a few cleaning cycles. The whole thing is compact too, which matters if you're stacking kegs in a kegerator or building out a mobile draft setup where every inch counts.

Paid perfectly with EVABarrier Tubing

Highlights

• Fits the gas post on any standard ball lock keg.
• Built-in 8mm Duotight push-in fitting eliminates the barb and clamp.
• Stainless steel spring and ball bearings resist sanitizers and caustics.
• Disassembles tool-free for fast, thorough cleaning.
• Compact body makes keg stacking easier in tight kegerators.
• Pairs with 8mm OD EVABarrier tubing for a leak-free connection.

Specifications

Connection Type

Ball lock, gas side (grey)

Fitting

Duotight 8mm push-in

Tubing Compatibility

EVABarrier tubing - Select appropriate size tubing

Internal Components

Stainless steel spring and ball bearings

Specifications