Atosa Bowl Holding Kit for PPM-20 PrepPal Mixer - PPM2004

This is the Atosa PPM2004 bowl holding kit, the bowl hold kit and clip for the Atosa PPM-20 PrepPal planetary floor mixer. It's the hardware you pull forward to lock the bowl onto its cradle before you start mixing.

Highlights

• Genuine OEM bowl holding kit for the Atosa PPM-20 PrepPal planetary floor mixer.
• Replaces the bowl hold kit and clip that locks the bowl onto the bowl cradle.
• Atosa's PPM-20 uses two of these per mixer.
• Match part number PPM2004 or the model number on your mixer's data plate.

Bowl Holding Kit for Atosa PPM-20 Fit and Specs

• Part number: PPM2004
• Fits: Atosa PPM-20 PrepPal mixer
• Quantity per mixer: 2

On the PPM-20 the bowl sits on pins on either side of the bowl cradle, and a bowl clamp on each side is pulled forward until the bowl is locked tight. Two clamps means two kits, so if one side is worn or broken you may want to look at both before you reorder.

To confirm the fit, match the part number PPM2004 against the part you're replacing, and check the model number on the mixer's data plate. The PPM-20 is Atosa's 20 quart planetary floor mixer.

If the bowl won't lock down or shifts while the mixer runs, the bowl holding kit is the part to check first. This is a genuine OEM part, so it matches the original in fit and function.

Atosa OEM Part. This part only works with Atosa brand equipment. Please contact our sales department to confirm it fits your machine before ordering. This product is not returnable.

Specifications