Atosa 36-Inch Dunnage Rack (12-Inch Height)

The Atosa ADR203612 is a 36 inch dunnage rack built to hold bulk product 12 inches off the floor in a walk-in cooler, dry storage room, or commercial kitchen. It's the same style of rack you'll see stacked with cases of produce or bagged goods in any restaurant back room, and at 36" wide by 20" deep it covers a good amount of floor space without eating up the whole room.

Highlights

• 36" x 20" platform gives more surface area than the 24" wide models in the same line.
• 12" height clears mop buckets and floor equipment while keeping product off the floor.
• Rated for 1800 lbs of evenly distributed weight.
• Fully welded 1-1/2" square aluminum tubing, no bolted joints to work loose.
• NSF listed for food service and cooler use.
• Aluminum construction won't rust in a wet walk-in environment.

Atosa ADR203612 Dunnage Rack Construction

The frame is fully welded from 1-1/2 inch square aluminum tubing, so there are no bolted joints to work loose or come apart under a full load. Because it's aluminum rather than steel, it won't rust or corrode even in a wet walk-in, which is exactly where a lot of dunnage racks end up living.

• Welded aluminum frame: No fasteners to tighten or replace over time.
• Slotted platform: Lets air move under and around stored product instead of trapping moisture against the floor.
• 12 inch clearance: High enough to run a mop or floor scrubber underneath without moving the rack.

36 Inch Dunnage Rack Specifications

• Dimensions: 36" W x 20" D x 12" H.
• Weight capacity: 1800 lbs, evenly distributed.
• Material: Welded aluminum, 1-1/2" square tubing.
• Certification: NSF listed.

NSF Dunnage Rack for Walk-In Cooler Storage

Keeping bulk goods off the floor is a basic food safety requirement in most health codes, and this rack is NSF listed for exactly that use in coolers and dry storage. The 1800 lb rating means it can carry a genuinely heavy pallet or stack of cases without flexing, and the open slotted top keeps air circulating around perishable product instead of letting it sit in a damp pocket against a solid shelf.

It's a straightforward, no-frills piece of equipment, and that's the point. There's nothing on it to break, no coating to chip, and no wood to rot. If you're setting up a walk-in or just need a solid, code-compliant spot to stage bulk product, the ADR203612 does the job.

Dimensions: 20" D x 36" W x 12" H. Material: Welded Aluminum. Capacity: 1800 lbs.

Specifications